How to Configure SIP Trunk to Service Provider Network?

Unlock Best Pricing with In-stock, Ready-to-Ship Products

In this article we will cover the sample configuration for configuring the SIP Trunk to more than one Service provider on Cisco Unified Border Element (CUBE).

sp_network-Configuration

There are two parts in this article: Sample configuration & Requirement from SIP Trunk Service Provider

Sample Configuration

interface loopback1
 ip address 10.10.10.1 255.255.255.0

interface loopback2
 ip address 20.20.20.2 255.255.255.0

dial-peer voice 1 voip
 description “Primary path to sip sp-1”
 destination-pattern 91[2-9]……
 session protocol sipv2
 session target ivp4: 10.10.10.2
 voice class sip options-keepalive
 voice-class sip bind control source-interface loopback1
 voice-class sip bind media source-interface loopback1

dial-peer voice 2 voip
 description “secondary path to sip sp-2”
 destination-pattern 91[2-9]…..
 session protocol sipv2
 session target ipv4:20.20.20.2
 preference 2
 voice-class sip options-keepalive
 voice-class sip bind control source-interface loopback2
 voice-class sip bind media source-interface loopback2

Note: Dual SPs can be used for outbound calls.

 

More Tech Note Here:  Information you require from SP while Provisioning SIP Trunk

What you should get from the Service Provider for provisioning SIP Trunk

Requirement from SIP Trunk Service provider

1. SIP Trunk IP Address ie Destination IP address for INVITES.  For example – 20.1.1.4 or DNS
2. SIP Trunk Port Number ie Destination port number for INVITES. – 5060
3. SIP Trunk Transport layer (TCP/UDP)  – UDP
4. Codecs supported  – G711, G729
5. Fax protocol support. For example – T.38
6. DTMF signaling mechanism. For example – RFC2833
7. Does the provider require SDP information in initial INVITE (Early offer required) – Yes
8. SBC’s External IP address that is required for service provider to accept/authenticate calls ie source ip address for INVITE – 20.1.1.1
9. Does SIP require SIP Trunk registration for each DID? If yes what is the username and password. 
10. Does SIP require Digest Authentication? If yes what is the username and password.

Information you require from SP while provisioning SIP Trunk

More Related Information about CUCM with CUBE Configuration: CUCM with CUBE Configuration Example

 

More “How to” Guides Related to Cisco Hardware & Network

How to Save Power on Cisco IP Phones?

How to Set up a Perfect Network? With Examples…

How to Activate a Cisco License?

Cisco VPN Phone Configuration  …

Share This Post

Post Comment