Tutorial: How to Wire an RJ-45 Console Cable?

Unlock Best Pricing with In-stock, Ready-to-Ship Products

Routers and network switches typically require an RS232 serial data connection to interface with the device for initial configuration. Serial data connections may also be used for diagnostics purposes, especially when a network device is malfunctioning and unreachable over the network. Cisco switches and routers now require a specially configured RJ45 console cable when communicating with the devices through a serial connection. Build an RJ45 console cable in order to connect, configure or troubleshoot a Cisco device.

Kits You Need to Wire Cisco Console Cable

  • RJ45-to-DB9 adapter kit
  • Standard CAT6 or CAT5 patch cable
  • Phillips screwdriver

RJ45-to-DB9 adapter kit

Instructions to Wire an RJ-45 Console Cable

1. Remove the screws on the cover of the DB9-to-RJ45 adapter kit and then remove the cover from the RJ45 connector.

2. Plug the wires that extend from the RJ45 connector into the back of the DB9 connector according to the pinout below:

DB9 pin 8 to RJ45 pin 1

DB9 pin 6 to RJ45 pin 2

DB9 pin 2 to RJ45 pin 3

DB9 pin 5 to RJ45 pin 4

DB9 pin 3 to RJ45 pin 6

DB9 pin 4 to RJ45 pin 7

DB9 pin 7 to RJ45 pin 8

Note that the RJ45 adapter pins are numbered from left to right when looking at the RJ45 socket with the tab up. The DB9 connector pins are labeled with the pin number next to each pin in small writing.

3. Snap the cover back onto the RJ45-to-DB9 adapter. Tighten the screws to secure the cover.

4. Connect a CAT5 or CAT6 standard patch cable to the RJ45 connector end of the adapter. The Cisco console cable is now ready for use.

More Notes:

Cisco RJ45 Rollover Cable Pinout

Rollover Cable:

You can identify a roll-over cable by comparing the two modular ends of the cable. Holding the cables side-by-side, with the tab at the back, the wire connected to the pin on the outside of the left plug should be the same color as the wire connected to the pin on the outside of the right plug. If your cable was purchased from Cisco Systems, pin 1 will be white on one connector, and pin 8 will be white on the other.

Uses of Rollover Cable:

Rollover cables, like other cabling types, got their name from how they are wired. Rollover cables essentially have one end of the cable wired exactly opposite from the other. This essentially “rolls over” the wires- but why would we need to do such a thing? Rollover cables, also called Yost cables, usually connect a device to a router or switch’s console port. This allows a programmer to make a connection to the router or switch, and program it as needed.

PC to Console Port

Router AUX port to External Modem

Router
Pin name
Router
Pin
Direction Workstation
Pin
Workstation
Pin name
White-Orange 1 8 Brown
Orange 2 7 White-Brown
White – Green 3 6 Green
Blue 4 5 White-Blue
White-Blue 5 4 Blue
Green 6 3 White-Green
White-Brown 7 2 Orange
Brown 8 1 White-Orange

Share This Post

Post Comment